The common pads are as follows:
1. Wedge iron: rectangular niobium iron with a slope of 1:10 on one side. It is not convenient to adjust the wedge and contact with the base line of the CNC bending machine. Rigidity is not high, only used for small, low – requirement CNC bending machine, after installation without adjustment.
2. Hook-head horn: it is suitable for the general medium and small-sized CNC bending machine with large vibration and 10-15t weight.
3. Screw adjusting horn: screw adjusting is convenient and accurate. However, for precision CNC bending machine, there is a contrast between the horn slider and CNC bending machine
The slide.
4. Horn of CNC bending machine: during adjustment, there is no relative sliding between the upper horn and the body of CNC bending machine.
5. Jack horn: for CNC bending machine without anchor bolt. Especially suitable for high precision CNC bending machine.
6. Installation adjustment mechanism with threaded sleeve: when adjusting, loosen the nut and lock nut in turn, rotate the screw sleeve to adjust the level, and finally tighten the lock nut and nut in turn. Adjustment is convenient and accurate, the adjustment range is large, but the base should use screw hole processing.
